NO
AU
B2A5811

This DTC indicates a short to ground in the driver-side face vent (FACE mode) temperature sensor signal circuit — Atto 3

Thermal Management System

This DTC indicates a short to ground in the driver-side face vent (FACE mode) temperature sensor signal circuit.

The sensor is an NTC (negative temperature coefficient) thermistor.

During normal operation, it sends a 0.5-4.5V analog voltage signal to the air conditioning control unit (ACU) to indicate the vent outlet temperature.

When the ACU detects the signal voltage remains below 0.1V (logic low threshold) for longer than the set time (typically 200-500ms), it determines a short to ground.

This fault causes the ACU to enter Limp Home Mode, disables independent dual-zone temperature control, and may lock the driver-side temperature flap in the full cold or full hot position, severely affecting air conditioning comfort.

In extreme cases, continuous full-load compressor operation affects overall vehicle energy consumption.

5
Cases Logged
Real-World Cases
BYD DTC AI Analysis

Song MAX temperature sensor wiring harness worn after dashboard removal and installation

✓
Vehicle: 2018 Song MAX 1.5T. Symptom: After removing and reinstalling the dashboard to replace the evaporator, the AC panel displayed ‘E1’. Scan tool read DTC B2A5811. Diagnosis: Sensor resistance was normal. Measured the harness-side signal wire: continuity to ground. Removed the dashboard again and found the harness pinched under the crossmember bracket during reassembly. The insulation had worn through, shorting the copper core to chassis. Repair: Repaired the damaged harness, wrapped it with abrasion-resistant corrugated tubing, and rerouted it away from sharp metal edges. Fault cleared.
BYD DTC AI Analysis

Water ingress and corrosion caused intermittent short circuit in Qin Pro EV sensor.

✓
Vehicle: 2019 Qin Pro EV. Symptoms: AC malfunctions after rain or car washing, fault light on; returns to normal in dry weather. Diagnosis: Read historical DTC B2A5811, intermittent. Found green copper corrosion inside the temperature sensor connector beneath the evaporator housing; sealing ring deteriorated. Water caused a short between the signal terminal and sensor metal housing. Solution: Cleaned connector terminals, replaced sensor and sealing ring, applied waterproof silicone grease to the connector. Fault has not reoccurred.
BYD DTC AI Analysis

Qin EV AC control module internal circuit damage

✓
Vehicle: 2017 Qin EV300. Fault: Air conditioning not cooling; no airflow from driver's side vents. Diagnosis: Retrieved DTCs B2A5811 and B2A5813 (open circuit) alternating. Measured sensors and wiring harness – normal. Testing ACU output found 5V reference voltage shorted to ground. Disassembled the ACU; filter capacitor in the internal sampling circuit had broken down. Solution: ACU is an integrated module. Replaced the assembly, programmed and matched. Fault resolved.
BYD DTC AI Analysis

Song MAX temperature sensor body deteriorated and shorted

✓
Vehicle: 2017 Song MAX, 80,000 km. Symptom: Auto climate mode inoperative, continuously blowing hot air. Diagnosis: Data stream showed driver-side face vent temperature sensor fixed at -40°C (default substitute value used by ACU when detecting short to ground). Measured resistance between sensor terminals: 0.2Ω, confirming internal thermistor short. Solution: Replaced driver-side face vent temperature sensor (Part No.: EG-8120410). After clearing DTCs, temperature display returned to normal and auto climate function restored.
BYD DTC AI Analysis

Aftermarket modification caused wiring harness short circuit

✓
Vehicle: 2019 BYD Qin Pro DM. Fault: AC fault code B2A5811 appeared after installing a 360-degree panoramic camera system. Diagnosis: The retrofit shop pierced the AC temperature sensor harness while fishing wires behind the dashboard with steel wire, causing the signal wire to short against the dashboard metal frame. Repair: Repaired the two damaged wires (signal and ground), insulated them with heat-shrink tubing, and rerouted the aftermarket harness to avoid the factory cable-tie locations.
Other Atto 3 Fault Codes
P0A0DBattery Energy Control Module Requested MIL IlluminationP0AA6Hybrid Battery Voltage System Isolation FaultP1A00Drive Motor "A" Performance — BYD proprietaryB1108For the BYD Song MAX (2017–2019), DTC B1108 indicates a short circuit in the PM2.5 air quality detection module (dust sensor) or its wiring harness. The sensor uses laser scattering to detect in-cabin and outside PM2.5 concentrations and transmits data to the HVAC ECU via the LIN bus or an analog signal. Short circuit conditions include: 1) Sensor power supply wire (+5V/+12V) shorted to ground 2) Signal wire shorted to power or ground 3) Short circuit in the sensor's internal photoelectric detection circuit This fault prevents the automatic climate control from switching between fresh air and recirculation based on air quality. The system enters fail-safe mode (typically forced recirculation). Severe short-circuit current can destroy the HVAC ECU sampling circuit. The system classifies this as a Level 3 severe fault and restricts vehicle operation to prevent electrical fires or controller damage. For other BYD models (such as the Qin EV, E5, and Song DM), B1108 indicates a driver-side sunload sensor fault, reflecting differences in DTC definitions across models.B110811This DTC indicates a short circuit in the air conditioning system PM2.5 air quality sensor (rapid detector). Specifically, abnormal continuity exists between the sensor power supply circuit or signal output circuit and body ground or battery positive. This causes the control module (ACU/air conditioning controller) to detect abnormal current or a voltage signal outside the valid range (typically 0V or supply voltage). The PM2.5 sensor monitors internal and external particulate concentrations, providing the data the automatic air conditioning system uses to switch between fresh air and recirculation modes. A short circuit disables the air quality monitoring function. This fault may force the air conditioning system into recirculation protection mode and trigger related thermal management system faults, as the air conditioning system acts as a key actuator in vehicle thermal management. In severe cases, the short circuit current can damage the internal sampling circuit of the air conditioning controller or overheat the wiring harness.
Data confidence: Community This information is for reference only. Always consult a qualified technician for diagnosis and repair. Do not attempt high-voltage system repairs yourself.