NO
AU
B16A7

DTC B16A7 indicates the airbag control unit (SRS ECU) internal self-check detected a systemic fault — Seal U

Safety System

DTC B16A7 indicates the airbag control unit (SRS ECU) internal self-check detected a systemic fault.

This fault involves abnormalities in the SRS ECU internal microprocessor, memory (EEPROM/Flash), power management circuit, or watchdog circuit.

Specific causes include an internal 5V/3.3V reference voltage regulator fault, an acceleration sensor (Satellite Sensor) communication timeout, an internal algorithm self-check failure, or a non-volatile memory data checksum error.

Upon detecting this fault, the SRS ECU enters Fail-Safe Mode.

This mode may disable some or all airbag deployment and seat belt pretensioner activation functions, and illuminate the instrument cluster airbag warning light.

Because the airbag system is a critical passive safety system, this fault indicates the vehicle may fail to provide the designed occupant protection during a collision, creating a severe safety hazard.

5
Cases Logged
Real-World Cases
BYD DTC AI Analysis

Voltage drop at Tang DM-i startup instant causes intermittent B16A7 fault.

✓
Symptoms: 2021 BYD Tang DM-i with 30,000 km. Owner reported the airbag warning light occasionally illuminated during cold starts, automatically going out after driving for some time. Diagnosis: Connected the scan tool and retrieved stored DTC B16A7. Freeze frame data showed battery voltage at 8.1V when the fault occurred. Measured voltage during cranking and found it dropped to 7.8V with the starter motor engaged. Inspected the battery terminals and found negative earth point G301 corroded and loose. Repair: Removed the earth point, cleaned the contact surfaces with sandpaper, applied conductive grease, and tightened to the specified torque of 10 N·m. Replaced the aging battery. Fault resolved.
BYD DTC AI Analysis

Yuan EV SRS ECU connector corroded from water ingress after wading

✓
Symptoms: A 2019 Yuan EV developed DTCs B16A7 and B16A5 after driving through heavy flood water, with the airbag warning light staying on. Diagnosis: The vehicle had water reaching the floor level. The SRS ECU is mounted beneath the centre console. Upon removal, the 24-pin connector showed visible water ingress. Terminals A03 (ignition power) and A12 (earth) had green copper corrosion, and contact resistance measured 5.2 Ω (specification <0.1 Ω). Solution: Thoroughly cleaned the connector using electronic contact cleaner, replaced the damaged terminals, applied waterproof sealant, replaced the SRS ECU seal ring, and dried the components. The fault cleared.
BYD DTC AI Analysis

Outdated Song MAX software caused false low temperature detection.

✓
Symptoms: 2019 Song MAX, B16A7 fault appears frequently on winter morning startup, always appears when ambient temperature is below 5°C, clears once the vehicle warms up. Diagnosis: Checked power supply, earth, and wiring harness – all normal. Retrieved SRS ECU software version V1.02.03. Consulted Technical Service Bulletin (TSB) and confirmed this version has a bug with overly strict low-temperature self-test thresholds. Solution: Connected VDS2000, downloaded latest software V1.05.02, performed online programming reflash. After reflash, performed system configuration (selected correct airbag configuration level). Conducted low-temperature cold start testing for 3 consecutive days – fault did not return.
BYD DTC AI Analysis

Aftermarket dash cam on Qin Pro interfering with CAN bus

✓
Symptoms: 2020 Qin Pro petrol version. After the owner fitted a dashcam (tapped into constant +B power), the airbag warning light illuminated randomly while driving, logging DTC B16A7. Diagnosis: Disconnected the dashcam power and road-tested 50 km. The fault did not reoccur. Measurements revealed the dashcam power cable was generating high-frequency noise that coupled through the wiring to the SRS ECU, causing an increased bit error rate in the internal CAN transceiver and triggering the fail-safe mode. Solution: Removed the direct power connection, rewired the dashcam to the ACC relay (ignition-switched power), and added a ferrite core filter to the power lead. Fault resolved.
BYD DTC AI Analysis

Tang EV SRS ECU internal damage after accident repair

✓
Symptoms: 2021 Tang EV. After front collision repairs, the SRS warning light stays on constantly. DTC B16A7 is present and cannot be cleared. Diagnostic process: The shop replaced the front impact sensors and airbag module after the accident, but did not replace the SRS ECU—it looked undamaged. The ECU’s internal accelerometer output showed severe X-axis signal drift (should read 0g at rest; actual reading 0.8g). The collision impact had physically damaged the internal MEMS sensor. Solution: Replaced the SRS ECU with a new unit, performed online programming and coding (input vehicle VIN and configuration codes), and ran a comprehensive system self-test. All airbag circuit resistances read normally (2.0–3.0Ω). Fault resolved.
Other Seal U Fault Codes
B1108For the BYD Song MAX (2017–2019), DTC B1108 indicates a short circuit in the PM2.5 air quality detection module (dust sensor) or its wiring harness. The sensor uses laser scattering to detect in-cabin and outside PM2.5 concentrations and transmits data to the HVAC ECU via the LIN bus or an analog signal. Short circuit conditions include: 1) Sensor power supply wire (+5V/+12V) shorted to ground 2) Signal wire shorted to power or ground 3) Short circuit in the sensor's internal photoelectric detection circuit This fault prevents the automatic climate control from switching between fresh air and recirculation based on air quality. The system enters fail-safe mode (typically forced recirculation). Severe short-circuit current can destroy the HVAC ECU sampling circuit. The system classifies this as a Level 3 severe fault and restricts vehicle operation to prevent electrical fires or controller damage. For other BYD models (such as the Qin EV, E5, and Song DM), B1108 indicates a driver-side sunload sensor fault, reflecting differences in DTC definitions across models.B110811This DTC indicates a short circuit in the air conditioning system PM2.5 air quality sensor (rapid detector). Specifically, abnormal continuity exists between the sensor power supply circuit or signal output circuit and body ground or battery positive. This causes the control module (ACU/air conditioning controller) to detect abnormal current or a voltage signal outside the valid range (typically 0V or supply voltage). The PM2.5 sensor monitors internal and external particulate concentrations, providing the data the automatic air conditioning system uses to switch between fresh air and recirculation modes. A short circuit disables the air quality monitoring function. This fault may force the air conditioning system into recirculation protection mode and trigger related thermal management system faults, as the air conditioning system acts as a key actuator in vehicle thermal management. In severe cases, the short circuit current can damage the internal sampling circuit of the air conditioning controller or overheat the wiring harness.B1109DTC B1109 indicates an open circuit in the communication line between the air conditioning system PM2.5 air quality sensor (dust concentration sensor) and the air conditioning control unit (AC ECU), or an open circuit within the sensor internal circuitry. Typically located in the air conditioning intake duct, this sensor monitors real-time PM2.5 particle concentration inside and outside the vehicle. It provides data to the automatic air conditioning system for intelligent switching between fresh air and recirculation modes and for controlling the air purification device. During an open circuit fault, the AC ECU cannot receive the air quality signal, triggering the system fail-safe mode. Symptoms typically include failure of the automatic recirculation function, abnormal air purification indicator light operation, or abnormal air quality data displayed on the air conditioning panel. Severe cases may compromise the cabin environment control strategy, but do not directly affect vehicle driving safety.B110913DTC B110913 indicates an open signal circuit for the PM2.5 rapid detector (in-cabin air quality sensor). This sensor typically mounts inside the air conditioning system intake duct. It monitors in-cabin PM2.5 concentration in real time and provides data to the automatic air conditioning system for intelligent control of the air purification function. The BYD diagnostic protocol uses sub-code '13' to specifically indicate an open signal circuit. Although this fault theoretically affects a comfort feature, BYD Qin series vehicles classify it as a Level 3 (severe) fault. This classification occurs because the air conditioning system interacts with the battery thermal management system (e.g., monitoring battery cooling intake air quality). The fault can disable the automatic air conditioning mode and prevent the air purification function from operating. In extreme cases, it affects the battery compartment intake air quality assessment, triggering the 'repair immediately' strategy.B110AThis DTC indicates interrupted CAN bus communication or abnormal data between the air conditioning control unit (ACU) and the PM2.5 air quality sensor. The PM2.5 sensor monitors particulate concentration inside and outside the vehicle and provides the basis for purification control in the automatic air conditioning system. The ACU triggers this fault if it fails to receive a valid CAN message from the sensor within the specified period (usually 100-500 ms), if message verification fails, or if the signal frame times out. Although this fault does not affect vehicle driving safety, it disables the automatic air purification function. The air conditioning system cannot automatically switch between recirculation and fresh air modes or activate the air purification mode based on air quality. A persistent fault may restrict the thermal management strategy.
Data confidence: Community This information is for reference only. Always consult a qualified technician for diagnosis and repair. Do not attempt high-voltage system repairs yourself.