UAE
AU
B175C

DTC B175C indicates the airbag control unit (SRS ECU) detects that the igniter (squib) resistance for the right rear side airbag (typically located in the right rear seat backrest side or C-pillar area) exceeds the upper normal threshold — Atto 3

Safety System

DTC B175C indicates the airbag control unit (SRS ECU) detects that the igniter (squib) resistance for the right rear side airbag (typically located in the right rear seat backrest side or C-pillar area) exceeds the upper normal threshold.

The SRS system continuously monitors each airbag igniter's resistance via a low-current circuit; the normal range is typically 1.5-3.0 ohms.

If the resistance remains above approximately 3.5-4.5 ohms (specific thresholds vary by model), the system flags a 'resistance too high' condition.

This fault indicates a high-resistance state in the airbag circuit.

Possible causes include poor connector contact, a partially broken wiring harness, igniter degradation, or a faulty ECU internal sampling circuit.

Safety Impact: Insufficient current may prevent this airbag from deploying during a collision, or the system may trigger a safety strategy disabling the entire airbag system, degrading occupant protection.

3
Cases Logged
Real-World Cases
BYD DTC AI Analysis

Oxidized connector under right rear seat of Song MAX caused high resistance.

✓
A 2019 Song MAX with 42,000 km illuminated the airbag warning light. Retrieved DTC B175C. Removed the right rear seat and found obvious oxidation inside the yellow side airbag wiring harness connector. Terminal surface oxidation increased contact resistance to 5.2 ohms. Cleaned the terminals with electronic contact cleaner, applied conductive grease, and reconnected the connector. Resistance measured 2.1 ohms. Cleared the DTC; fault resolved. A rear passenger spilled a drink that seeped into the connector, causing the oxidation.
BYD DTC AI Analysis

BYD Tang DM: Frequent seat adjustment caused internal wiring harness wire strands to break

✓
2021 BYD Tang DM. Right rear side airbag intermittently setting DTC B175C. The side airbag igniter wiring harness routes through the seat frame on this model. Frequent forward/backward adjustment of the right rear seat (this owner uses it for child safety seat installation) broke the internal copper strands at the bend point while the outer sheath remained intact. Resistance measured intermittent, fluctuating between 3–8 ohms. Replaced the harness assembly, rerouted to add slack, and fitted an abrasion protection sleeve. Fault resolved.
BYD DTC AI Analysis

BYD Yuan EV Airbag Igniter Body Replacement Case – Aging

✓
2019 BYD Yuan EV. B175C appeared after 5 years and could not be cleared. With the harness disconnected, resistance from the SRS ECU to the airbag measured normal at 0.3 ohms. Direct measurement across the airbag assembly terminals showed 4.8 ohms, outside the 1.5–3.0 ohm range. Fault: internal igniter degradation. Replaced the right rear side airbag assembly; resistance returned to 2.3 ohms and the system self-test passed. On older vehicles, replace the airbag assembly directly.
Other Atto 3 Fault Codes
P0A0DBattery Energy Control Module Requested MIL IlluminationP0AA6Hybrid Battery Voltage System Isolation FaultP1A00Drive Motor "A" Performance — BYD proprietaryB1108For the BYD Song MAX (2017–2019), DTC B1108 indicates a short circuit in the PM2.5 air quality detection module (dust sensor) or its wiring harness. The sensor uses laser scattering to detect in-cabin and outside PM2.5 concentrations and transmits data to the HVAC ECU via the LIN bus or an analog signal. Short circuit conditions include: 1) Sensor power supply wire (+5V/+12V) shorted to ground 2) Signal wire shorted to power or ground 3) Short circuit in the sensor's internal photoelectric detection circuit This fault prevents the automatic climate control from switching between fresh air and recirculation based on air quality. The system enters fail-safe mode (typically forced recirculation). Severe short-circuit current can destroy the HVAC ECU sampling circuit. The system classifies this as a Level 3 severe fault and restricts vehicle operation to prevent electrical fires or controller damage. For other BYD models (such as the Qin EV, E5, and Song DM), B1108 indicates a driver-side sunload sensor fault, reflecting differences in DTC definitions across models.B110811This DTC indicates a short circuit in the air conditioning system PM2.5 air quality sensor (rapid detector). Specifically, abnormal continuity exists between the sensor power supply circuit or signal output circuit and body ground or battery positive. This causes the control module (ACU/air conditioning controller) to detect abnormal current or a voltage signal outside the valid range (typically 0V or supply voltage). The PM2.5 sensor monitors internal and external particulate concentrations, providing the data the automatic air conditioning system uses to switch between fresh air and recirculation modes. A short circuit disables the air quality monitoring function. This fault may force the air conditioning system into recirculation protection mode and trigger related thermal management system faults, as the air conditioning system acts as a key actuator in vehicle thermal management. In severe cases, the short circuit current can damage the internal sampling circuit of the air conditioning controller or overheat the wiring harness.
Data confidence: Community This information is for reference only. Always consult a qualified technician for diagnosis and repair. Do not attempt high-voltage system repairs yourself.